[Dantepartz]

I just noticed that the hole where the bolt goes into, the plastic broke off. Now it won’t hold onto it, and the coil 1 is loose because there’s no compression to hold it in place.
Is this a major problem I need to fix?
Is there another way I can fix this issue besides taking off the whole bracket

 

[RPW00Mirage]

sandwich it between two larger washers.

otherwise maybe someone would part with just the bracket but probably not likely.

 

[Dantepartz]

I’ll try the 2 washer technique.
I tried tightening to hold it in place but it kept slipping out when I had just one washer.
maybe if I just use a wire around the bolt but what wire would I be able to use since the bolt will get hot when running the engine.

 

[RPW00Mirage]

you need like 2 1-inch wide washers. maybe something like this with moveable tabs?

Lock washer Carbon Steel Tab Washers fit to Round Nut Φ10/12/20/27/30/36/40 - 60 | eBay

The permissible size variation is: tolerance, but they all fall within the scope of the industry regulations. When the product is ordered, the tolerance is accepted by default. ※ Material: carbon steel.

www.ebay.com

 

[Ricky-D]

Drill a small hole in the bracket and use a zip tie to secure it.

 

[Dantepartz]

Drill a small hole in the bracket and use a zip tie to secure it.

Thank you I’ll try that