Okay guys, time for my second how to.
Changing your map light bulbs for LED bulbs =D
Simple as pie, there are two ways to go about this.. i will post the easiest one first..
Easy way- (only good for led bulbs, not led board's
1- Open the sunglasses holder on the maplight housing.
2- Grab the actual clear light housing from the inside and pull out the
3- pull out the bulb, put yours in and your done
Hard way- Not really hard, but this way requires two more steps, and can will give you easier access to the bulbs so you can insert a led board style light.
1- Open the sunglasses holder in the maplight housing.
2- Inside the sunglass holder housing there are two phillips screws, take these out.
3- pull the entire housing out (from the windshield towards you).
4- Remove the two wires holding the housing in place by pressing on the clips on them..
5-You now have access to the housing.
6- Grab the actual clear light housing from the inside and pull out the housing.
7- remove bulb, insert your housing, follow steps in reverse and your done!
Thanks to the whole community who has been great to me so far. I have two more write ups in the works.